大多數情況下，發電機組的啟動困難故障一般為軟性故障（非機械部件損壞引發的故障，而機械部件損壞引發的故障相對容易判斷）。因此，當發電機組出現啟動困難故障后，首先需要判斷是油路系統因素還是電路系統因素所致。

　　In most cases, the difficulty in starting a generator set is generally due to soft faults (faults caused by non mechanical component damage, while faults caused by mechanical component damage are relatively easy to diagnose). Therefore, when the generator set experiences difficulty in starting, the first step is to determine whether it is caused by the oil system or the circuit system.

　　第一步：首先確保燃油系統沒有空氣和不存在漏氣點。

　　Step 1: First, ensure that the fuel system has no air and no leakage points.

　　第二步：判斷啟動機的運轉是否正常。如果啟動機運轉不正常，則說明故障可能是啟動系統自身因素（如電量不足或其他因素）所致；一般而言，啟動系統自身因素導致的發電機組啟動困難故障相對容易判斷和解決。而如果啟動機運轉正常且啟動轉速也正常，則問題一般不在啟動系統，可采取下列措施進一步確定故障點。

　　Step 2: Check if the starter is running normally. If the starter motor is not running properly, it indicates that the fault may be caused by internal factors of the starting system (such as insufficient battery or other factors); Generally speaking, it is relatively easy to identify and solve the difficulties and faults in starting a generator set caused by internal factors of the starting system. If the starter is running normally and the starting speed is also normal, the problem is generally not in the starting system, and the following measures can be taken to further determine the fault point.

　　①在啟動機帶動發電機組旋轉的同時，使用手油泵不停地泵油，如果此時發電機組可以啟動，說明故障原因是低壓油路系統供油不足。此時，可以進一步在低壓油路系統中查找原因（主要是觀察低壓油路系統是否有滲漏、堵塞或預壓不足等因素）。

　　① While the starter drives the generator set to rotate, the manual oil pump keeps pumping oil. If the generator set can start at this time, it indicates that the fault is due to insufficient oil supply in the low-pressure oil system. At this point, the cause can be further investigated in the low-pressure oil system (mainly by observing whether there are leaks, blockages, or insufficient pre pressure factors in the low-pressure oil system).

　　如果使用手油泵不斷地泵油，發電機組的啟動性能沒有任何改善，則問題一般不在低壓油路系統；此時應對發電機組的高壓油路系統（高壓泵、噴油器、共軌及其傳感器）、發電機組的電控系統及氣缸等部位進行相應的檢測。

　　If the manual oil pump continuously pumps oil and there is no improvement in the starting performance of the generator set, then the problem is generally not in the low-pressure oil system; At this time, corresponding inspections should be carried out on the high-pressure oil system of the generator set (high-pressure pump, injector, common rail and its sensors), the electronic control system and cylinders of the generator set.

　　②如果發電機組的燃油系統、啟動系統均正常，但發電機組仍然存在啟動困難現象，且啟動后發電機組運行過程中出現動力不足、燒機油、冒黑煙等異常現象，則故障一般在氣缸內部或配氣機構或進、排氣系統中。主要原因是氣缸磨損嚴重，氣門間隙錯誤，氣門機構磨損，氣門機械損壞，或進、排氣系統堵塞。此類故障的排除需要專業處理。

　　② If the fuel system and starting system of the generator set are normal, but there are still difficulties in starting the generator set, and abnormal phenomena such as insufficient power, oil burning, and black smoke occur during the operation of the generator set after starting, the fault is generally in the cylinder, valve mechanism, or intake and exhaust systems. The main reasons are severe cylinder wear, incorrect valve clearance, worn valve mechanisms, mechanical damage to valves, or blockages in the intake and exhaust systems. The troubleshooting of such faults requires professional handling.

　　③下列現象也可能導致發電機組啟動困難：

　　③ The following phenomena may also cause difficulties in starting the generator set:

　　a.進氣管存在堵塞（未完全堵死）導致進氣不暢。

　　a. The intake pipe is blocked (not completely blocked), resulting in poor air intake.

　　b.排氣消聲器及排氣后處理裝置等存在堵塞（未完全堵死）導致排氣不暢。

　　b. The exhaust muffler and exhaust after treatment device are blocked (not completely blocked), resulting in poor exhaust.

　　c.電控發電機組的相位傳感器（曲軸轉速傳感器和凸輪軸位置傳感器之一）故障可能導致發電機組啟動困難（部分機型可能不能啟動）。

　　c. The malfunction of the phase sensor (one of the crankshaft speed sensor and camshaft position sensor) of the electronic control generator set may cause difficulty in starting the generator set (some models may not be able to start).

　　d.電控發電機組個別噴油器線束故障、接插件故障或其他傳感器故障都可能導致發電機組出現啟動困難故障。

　　d. Individual fuel injector harness faults, connector faults, or other sensor faults in the electronic control generator set may cause difficulty in starting the generator set.

　　本文由  燃氣發電機組 友情奉獻.更多有關的知識請點擊  http://www.paicuan.cn/   真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from a gas generator set For more related knowledge, please click http://www.paicuan.cn/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.